17 NOV 14: Page 16-3 step 3 Left Wing: 1.75 hours

Continued to rivet rear spar of left wing.  Riveted my patch for my figure eighted hole – came out nice, all things considered:

18 NOV 14: Page 16-3 step 3, page 16-4 step 4 Left Wing: 4.2 hours

Finished riveting the left wing rear spar:

Riveted the outboard hinge bracket assembly to the wing assembly:

19 NOV 14: Page 16-3 step 3, page 16-4 step 4 Right Wing, page 18-2 step 4: 2.5 hours

Finished riveting the right wing rear spar. Riveted the outboard hinge bracket assembly to the wing assembly.  Both wing top skins are complete:

 20 NOV 14: Page 18-2 steps 2-4: 3.2 hours

Trimmed the T-1011 tank stiffeners and T-1008 vent line clips:

Trimmed the T-1012 tank attach Z brackets:

21 NOV 14: Page 18-2 steps 3-4: 3.25 hours

Finished cutting and deburring the T-1011 tank stiffeners, T-1008 vent line clips, T-1012 tank attach Z brackets, and T-1009 tank j-stiffeners:

 22 NOV 14: Page 17-4 step 5, built wing stand: 5.2 hours

Once again, friend and RV-14 builder Mike Hammond came over and we riveted both leading edges to the main spar assemblies.  Again, riveting goes super-fast with two people doing the job.  Both wing leading edges done:

Time to build the wing stand to get the work benches free for future work.  I decided to use this one that I found again and again online:

A couple hours later and the stand is complete.  It turned out pretty nice and it is nice to be able to easily move the wings around the shop: